|
[1] K. Pahlavan, A. Zahedi, and P. Krishnamurthy, “Wideband local access: Wireless LAN and wireless ATM,” IEEE Commun. Mag., pp. 34-40, Nov. 1997. [2] A. Matsuzawa, “RF-SoC-Expectations and Required Condition,” IEEE Trans. on Microwave Theory and Tech., vol. 50, no. 1, Jan. 2002. [3] P. R. Gray and R.G. Meyer, Analysis and Design of Analog Integrated Circuits, 3rd Edition, John Wiley & Sons Inc., 1993. [4] B. Razavi, RF Microelectronics, Prentice Hall Inc., 1998. [5] A. A. Abidi, “Direct-conversion radio transceivers for digital Communications”, IEEE J. Solid-State Circuits, vol. 30, pp. 1399-1410, Dec. 1995. [6] J. C. Rudell, J.-J. Ou, T. B. Cho, G. Chien, F. Brianti, J. A. Weldon, and P. R. Gary , “A 1.9GHz Wide-Band IF Double Conversion CMOS Receiver for Cordless Telephone Applications,” IEEE J. Solid-State Circuits, vol. 32, No. 12, Dec. 1997. [7] S. Sampei and K. Feher, “Adaptive DC-offset compensation algorithm for burst mode operated direct conversion receiver,” in Vehicular Technology Society 42nd VTS Conf., Denver, CO, May 1992, vol. 1, pp. 93-96. [8] U. L. Rohde and D. P. Newkirk, RF/Microwave Circuit Design for wireless Applications, John Wiley & Sons Inc., 2000. [9] K. H. Li, “2.4-GHz CMOS RF Image-Reject Receiving Circuits”, MS Thesis, EE Department, NTU, Jun. 2001. [10] P. Orsatti, F. Piazza and Q. Huang, “A 20-mA-Receiver, 55-mA-Transmit, Single-Chip GSM Transceiver in 0.25-um CMOS,” IEEE J. Solid-State Circuits, vol. 34, pp. 1869-1880, Dec 1999. [11] B. Razavi, RF Microelectronics: Chapter 5, Transceiver Architecture, Prentice Hall Communication Engineering and Emerging Technology Series, 1997. [12] T. H. Lee, The design of CMOS Radio-Frequency Integrated Circuits, Cambridge University Press, 1998. [13] Tajinder Manku, “Microwave CMOS — Devices and Circuits,” IEEE Custom Integrated Circuits Conference, 1998. [14] Z. Y. Chang and W. M. Sansen, Low-noise wide-band amplifier in Bipolar and CMOS technologies, Kluwer Academic, 1991. [15] H. Samvanti, H. R. Retegh and T. H. Lee, “A 5-GHz CMOS Wireless LAN Receiver Front End”, IEEE J. Soild-State Circuits, Vol. 35, No. 5, May. 2000. [16] U. L. Rohde and D. P. Newkirk, RF/Microwave Circuit Design for wireless Applications, John Wiley & Sons Inc., 2000. [17] A. Rofougaran, J. Y.-C. Chang, M. Rofougaran and A. A. Abidi, “A 1-GHz CMOS RF Frond-End IC for a Direct-Conversion Wireless Receiver,” IEEE J. Solid-State Circuits, Vol. 31, No. 7, July. 1996. [18] J. Chang, “An integrated 900MHz Spread-Spectrum Wireless Receiver in 1-um CMOS and a Suspended Inductor Technique: Final Report”, Integrated Circuits & System Laboratory, EE Department, UCLA, March 1998. [19] S. Wu and B. Razavi, “A 900-MHz/1.8-GHz CMOS Receiver for Dual-Band Applications,” IEEE J. Solid-State Circuits, Vol. 33, No. 12, pp. 2178-2185, Mar. 1998. [20] Y. S. Huang, “Design and Realization of 2.4 GHz CMOS RF Front-end Receiving Circuit”, MS Thesis, EE Department, NTU, Jun. 2000. [21] A. R. Shahani, D. K. Shaeffer, and T. H. Lee, “A 12-mW Wide Dynamic Range CMOS Front-End for a Portable GPS Receiver,” IEEE J. Solid-State Circuits, vol. 32, no. 12, Dec. 1997. [22] P. Ritger and N. Rose, Differential Equations with Applications, McGraw-Hill, 1968. [23] D. Ham and A. Hajimiri, “Complete Noise Analysis for CMOS Switching Mixers Via Stochastic Differential Equations,” IEEE Custom Integrated Circuits Conference, 2000.
|